This is historical information of device classes implemented in NeslabEx device server.
Use this link to find the valid information.
Development status:
Released
Information status: New
Contact:
Class Description
- NESLAB EX Bath/Circulator Tango device server
- Tested hardware : Neslab EX17
Families: SampleEnvironment
Key words:
Language: Cpp
Contact:
Class interface
Attributes:
| Name | Description |
|---|---|
| channelScalar: DevLong | — |
| controlSensorScalar: DevLong | — |
| gasAutoScalar: DevBoolean | — |
| gasFlowScalar: DevDouble | — |
| heaterAutoScalar: DevBoolean | — |
| heaterMaxScalar: DevDouble | — |
| heaterPercentScalar: DevDouble | — |
| pidAutoScalar: DevBoolean | — |
| temperatureScalar: DevDouble | — |
| temperature1Scalar: DevDouble | — |
| temperature2Scalar: DevDouble | — |
| temperature3Scalar: DevDouble | — |
| temperatureErrorScalar: DevDouble | — |
| temperatureMaxScalar: DevDouble | — |
| temperatureMinScalar: DevDouble | — |
| temperatureSetPointScalar: DevDouble | — |
| versionScalar: DevString | — |
| pidProportionalFactorScalar: DevDouble | — |
| pidIntegralTimeScalar: DevDouble | — |
| pidDifferentialTimeScalar: DevDouble | — |
Commands:
| Name | Description |
|---|---|
| StateInput: DevVoid Output: State |
This command gets the device state (stored in its device_state data member) and returns it to the caller. |
| StatusInput: DevVoid Output: DevString |
This command gets the device status (stored in its device_status data member) and returns it to the caller. |
| SendCmdInput: DevString Output: DevString |
Not implemented. For compatibility with other devices |
| StartInput: DevVoid Output: DevVoid |
Turn the controller ON |
| StopInput: DevVoid Output: DevVoid |
Turn the controller OFF |
Pipes:
Properties:
| Name | Description |
|---|---|
| CommProxyDevString | Communication proxy device name. For the Neslab Ex17 in RS-232 mode the Serial device must be configured in 19200 baud, 1 stop bit, no parity |
| CommTypeDevLong | Communication interface type 0 = RS-232 1 = RS-485 |
| CommAddrDevLong | Communication interface address RS-232 : must be 1 RS-485 : address of the controller (0x01-0x64) on the bus |
| EnableSecondSensorDevBoolean | — |
| PIDDouble[]Type | PID[0] = control Proportionnal factor PID[1] = control Integral time PID[2] = control Differential time |
20 Apr 2017, Piotr Goryl
Updated:
The device class has been updated.
You are looking at this version now.
23 Feb 2017, Piotr Goryl
Created:
The device class has been added to catalogue.
Updated:
The device class has been updated.
You are looking at this version now.
23 Feb 2017, Piotr Goryl
Created:
The device class has been added to catalogue.
Added by:pgoryl2
on:20 Apr 2017, 1:15 p.m.